Search the Community
Showing results for tags 'MSP430'.
Hello Everyone Using Invensenses Motion Driver, I want to read about 8 MPU6050. With AD0 connecting to 0 and 1, 2 sensors could be read successfully. I plan to control AD0 pin with MSP430 GPIO, with reading one sensor at a time (using concept one unique slave address over I2C), interrupts will be connected to one port to indicate availability of data in buffer. I need some guidance through the process. Has anyone been able to read more than 2 MPUs using Motion Driver ?? If yes, how is it done ? Thanks in advance
Hello Everyone, I have a small query, can I use motion drivers provided by Invensense on a general purpose MSP430 evaluation board and read sensor data with UART ?? I don't want to purchase Evaluation Board from Invensense as I want to make some hardware and software changes in order to read multiple MSP6050 using single MSP430 controller. I need preliminary suggestion so I can go ahead and purchase the stuff I need. regards, Mandar
Hi, I am currently working on a project where I am required to interface the MSP430g2553 with the MPU6050 and receive the raw values. I tried out several programs from the internet and none of them seem to work.I managed to find a working code which seems to give out lots of garbage values and also the values are not stable. It would be very much helpful if you could provide me with a working code or help me with debugging the code. I have attached the CCS project along with this post.