Jump to content
I2Cdevlib Forums

MPU-6050 with no interrupt pin - is DMP access possible?


Recommended Posts

Hey all,

 

I have an MPU-6050 connected to a simple board, with only SCL, SDA and voltage/GND outputs. Meaning, no INT pin to connect to my Arduino (I am using Teensy 3.2).

 

Now I don't know a whole lot about these things, but going by the sketches I've seen so far (well, basically the one sketch by the almighty Jeff) - it is required to use the INT pin in order to access the DMP.

Is that just the way the sketch is built, or am I screwed by this board not having the INT output? Because I would really love to get Euler angles or quaternions but I've only seen these calculations done reliably through the DMP.

 

 

Any help would be appreciated.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...