Jump to content
I2Cdevlib Forums

MPU6050 Reads 0 at times


Recommended Posts

Hi,

I'm using MPU6050 for a wearable application and the IC responds well at times but gives out 0 acceleration at times even though  Device-ID is read correct always.

It is also found that, once I heat the IC with a hot air gun, it works again. In the datasheet provided by the link below, it is said  under section 11.4 Assembly Precautions that the 

exposed pad must not be soldered, but I have it soldered it in my target board and it is also mentioned that thermo-mechanical stress will affect the IC .

I also have a buzzer in my board, will it be as reason too?

 

Regards,

Joe

https://www.google.co.in/search?q=MPU-6000+and+MPU-6050+Product+Specification+Revision+3.4&rlz=1C1CHWL_enIN764IN764&oq=MPU-6000+and+MPU-6050+Product+Specification+Revision+3.4&aqs=chrome..69i57.325j0j4&sourceid=chrome&ie=UTF-8

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...