Leaderboard

Hey everyone! Thought I'd share my version of an auto-offset calibration sketch; it converges all offsets in about 20s or so. Just upload and watch the serial (at 38400bps)! A note on how it works/converges: - the code takes an initial guess for each offset (supplied at the top of the sketch), takes a certain number of readings from the MPU-6050 (the # of readings it takes is defined by countMax), and averages those number of readings. If that average is less than the value errorCheck, it assumes that axis has converged - if the average isn't less than errorCheck, it will subtract a certain amount from the initial guess - if the errorCheck you set is too small, or the initial guess is smaller than what the solution is, it wont converge - in this case either choose a larger value for errorCheck or a larger initial guess I've given some initial guesses / settings which should help you get to where you need to be; just watch the serial - it'll tell you what the average reading from the MPU-6050 was for each guess, you'll want that average to be as close to 0 as possible for each axis. Enjoy! MPU6050_calibration.zip