Jump to content
I2Cdevlib Forums

Kryzzalid

Members
  • Content Count

    2
  • Joined

  • Last visited

Everything posted by Kryzzalid

  1. I figured out the reason. The board wasn't perfectly perpendicular to the gravitational acceleration vector. I forgot about that...
  2. Hi! I've got the MPU-9250 working but there seems to be some problem with the accelerometer. When the board is moving and then at rest, the values of the accelerometer don't go back to the "resting values" (ideally it would be (x, y, z) = (0,0,0)). To make this clear I attached the image "accelerometer.png". For this image: between 1.5s to 3.2s I move the board, then leave it at rest for about 2 seconds and then I move it again for 1.7s and then I leave it at rest again. After each time, the values at rest of the axes X Y Z are different. It is like the registers stop updating when the board doesn't move any more even if the values didn't come back to the origin. Maybe, there is some threshold. The gyroscope doesn't have that problem. At rest, the values come back nicely to the "rest values". The module is initialized with the following command: I2CSend(MPU9250_ADDRESS, 2, PWR_MGMT_1, 0x00); // Clear sleep mode Delay; I2CSend(MPU9250_ADDRESS, 2, PWR_MGMT_1, 0x01); // Clock Source Delay; I2CSend(MPU9250_ADDRESS, 2, CONFIG, 0x06); // Gyroscope Filter BW = 5Hz, delay = 33,48ms, Fs = 1kHz Delay; I2CSend(MPU9250_ADDRESS, 2, PWR_MGMT_2, 0x00); // Enable Accelerometer and gyroscope Delay; I2CSend(MPU9250_ADDRESS, 2, GYRO_CONFIG, 0x00); // +-250dps Delay; I2CSend(MPU9250_ADDRESS, 2, ACCEL_CONFIG, 0x00);// +-2G Delay; I2CSend(MPU9250_ADDRESS, 2, ACCEL_CONFIG_2, 0x05); // Accelerometer Filter BW = 10Hz, delay = 35,70ms, Fs = 1kHz Delay; I2CSend(MPU9250_ADDRESS, 2, INT_PIN_CFG, 0x02); // Bypass for the magnetometer enable Delay; I2CSend(MPU9250_ADDRESS, 2, I2C_MST_CTRL, 0x00); // I2C speed at 358 kHz Delay; I2CSend(MAG_ADDRESS, 2, MAG_CNTL_1, 0x00);// Power down magnetometer Delay; I2CSend(MAG_ADDRESS, 2, MAG_CNTL_1, 0x16); // sampling rate 100Hz and word is 16-bit Delay; I2CSend() writes values in the specified register. I thought first that it could be tied to the Wake on Motion thing. But even if I set it to 0x00, it doesn't change anything. Basically, I would like to have the values read continuously without any sleep or standby mode. Does anyone has an idea of what could be wrong? Thank you for your time!
×
×
  • Create New...