Jump to content
I2Cdevlib Forums
Sign in to follow this  
Joe Arun

MPU6050 Reads 0 at times

Recommended Posts

Hi,

I'm using MPU6050 for a wearable application and the IC responds well at times but gives out 0 acceleration at times even though  Device-ID is read correct always.

It is also found that, once I heat the IC with a hot air gun, it works again. In the datasheet provided by the link below, it is said  under section 11.4 Assembly Precautions that the 

exposed pad must not be soldered, but I have it soldered it in my target board and it is also mentioned that thermo-mechanical stress will affect the IC .

I also have a buzzer in my board, will it be as reason too?

 

Regards,

Joe

https://www.google.co.in/search?q=MPU-6000+and+MPU-6050+Product+Specification+Revision+3.4&rlz=1C1CHWL_enIN764IN764&oq=MPU-6000+and+MPU-6050+Product+Specification+Revision+3.4&aqs=chrome..69i57.325j0j4&sourceid=chrome&ie=UTF-8

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×