Jump to content
I2Cdevlib Forums

Recommended Posts

I'm working on a project that requiers high precision gyro Z axis on the atmega328 chip, in the mpu6050 lib it is explained that when you set dlpf mode to 0, the low pass filter is disabled and sample rate is set to 8kHz.

That's what the invensense docs says as well, but then what is the purpose of the option to set DLPF to 0 and sample at 8000Hz while the bandwidth is only 256kHz?

For some reason the output on 256kHz is very stable as if it was going through the low pass filter.

I know I could sample directly at 1kHz but this is wasting way too much my system recources, so sampling every 3.9ms at 256Hz is ok for me.

Any help is appreciated.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×