Hello i2cdevlib forums,
This is post seeking assistance with a little additional programming for the MPU6050-DMP6 sketch.
I am using the Sparkfun MPU6050 breakout board with an Arduino Micro strapped to the bottom of a skateboard to get data to compare the analytical mechanical model I am working on. The sketch works almost perfectly. When outputting quaternions, after anywhere from 5-30 seconds of vigorous movement the serial monitor stops giving me data. (Are there any fixes for this?)
My main request is for a addition to the sketch to allow the run to be stopped with another entering of a any key. Press an key to start, then press any key to stop kind of thing.
Or is there an arduino pin which I could wire that can send a high/low signal to turn off and on the arduino in order to capture the ollie data which is only 1-2 seconds long? Are there any other manual ways of doing this?
Any help or interest is greatly appreciated.
Adam Gomez
